![]() ![]() In the PPP (Point-to-Point) Example Application I tried to use _io_ras_install("ras:") and configure my PC like a ppp server. Now, Inside the _io_dun_install function we can see the following source code lines:īut inside the _io_ras_install function we can see it backwards: In the io_dun.c library are the drivers to communicate to Windows Dial-Up Networking or Windows NT RAS. This was made to install the Dial-Up Networking driver. Now, In the PPP (Point-to-Point) Example Application I noted the following lines at the PPP_start(void) function call: Then the negotiation begins and the client binds to the network through ppp. The Server responds with "CLIENTSERVER" Stringģ. The protocol for a CLIENT-SERVER ppp connection is:Ģ. } IPCP_DATA_STRUCT, _PTR_ IPCP_DATA_STRUCT_PTR Īnd I believe that it is possible to configure all the parameters of this struct to make the TWR52259 routes all the protocols from the application layer to another router and then to the internet just like it does over Ethernet. If that is possible, How can I do that then?ĭuring the PPP (Point-to-Point) Example Application test I noted the IPCP_DATA_STRUCT to send an e-mail, httpd server, FTP client/server, TCP/IP socket)?ģ. ¿Would that be transparent to the application layer of the TWR52259 (i.e. TWR52259 -Ethernet cable- GATEWAY - internetĢ. TWR52259 -ppp over uart- GATEWAY - internet Is it possible to implement a PPP connection between the TWR52259 and a gateway through the serial UART and be bound to internet just like it is possible with an Ethernet cable connected to the LAN? Regarding the reply answer about that there is no a PPP client implementation yet for TWR52259, I have some questions:ġ. ![]() a router, or a modem) and therefore have internet connection through the serial UART cable. Now, what I need is to make the TWR52259 gets connected to a Gateway (i.e. ![]() The TWR52259 is the ppp server and my computer is the ppp Client and the PC gets the IP address from the TWR52259.Īnd I can ping between them and they respond each other. ![]() I have successfully tested the PPP (Point-to-Point) Example Application. "Currently we don’t have a PPP client, however it is under development and will be available on MQX 3.8 version." I had a reply to a service request: SR# 1-784694661 ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |